濟南飼料機械廠
聯系人：安經理
手機：152-5313-4653
郵箱：347299818@qq.com
地址：濟南市濟北開發區
1.機組必須有接地和漏電保護裝置，確保工作人員的人身安全。
Unit must be grounded and leakage protection devices to ensure the safety of staff.
2.機器運行時，受，木棒，鐵騎嚴禁伸入機器內，不得打開機器維修門。
When the machine is running by, sticks, cavalry prohibited inserted into the machine, do not open the door machine maintenance.
3.喂料口堵塞時請勿用手，木棒，鐵棍等物料強行喂入，可暫停機器待喂料口清理后再繼續工作。
Do not hand when feeding port blockage, sticks, iron rods and other materials forced feeding, feeding port can pause the machine to be cleaned before continuing work.
4.一般情況下請勿帶負荷啟動機組。待機器運轉正常時，調整控制插板至適當位置，主副料應均勻喂料，以電機不超負荷為準。
Under normal circumstances do not start with a load unit. Until the machine is operating normally, adjust the control card to the appropriate location, primary and secondary materials should be uniform feed to the motor is not overloaded prevail.
5.更換孔徑小于4毫米以下篩片時，上料管上設置的進料插板應調整適當，否則上料多容易卡死磨盤，損壞篩底，燒壞電機及電器零件等。
Pore size of less than 4 mm below the replacement screen films, feeding tube feeding flapper setting should be adjusted appropriately, otherwise the material much easier stuck disc, damaged screen at the end, burn out the motor and electrical parts.
6.飼料攪拌機 組應安裝在遠離火源，通風，透光的場所。
Feed mixer set should be installed away from the fire, ventilation, light place.